The J-Link Measurement+Patch Adapter provides test points for all
debug signals to allow easy access for test probes. It has a standard
20-pin 0.1" socket towards the J-Link debug probe and a standard 20-pin
0.1" header on the target side and can directly be inserted between
the J-Link and the debug cable maintaining a 1:1 connection of all
debug signals. For increased flexibility VTref on pin 1 and the target
supply voltage on pin 19 can be interrupted by means of two jumpers.
J-Link Measurement+Patch Adapter allows easy customized wiring between
J-Link and targets that do not provide a standard debug connector
that has already been addressed by one of the many available J-Link adapters. The wiring between J-Link
and the target is done via colored jumper wires that are shipped with
the J-Link Measurement+Patch Adapter.
- Measurement Adapter Board
- 10 Jumper Wires for Manual Setup