No results were found for the filter!
Target Supply Adapter
The J-Link Target Supply Adapter provides a default voltage of 3.3 V to power the target using pin 19. The voltage can be adjusted by replacing resistors. Additional Product Information on segger.com
€68.00
*
Flying Wire Adapter
Adapts from the standard 20 pin 0.1" J-Link connector to a 10-pin row, allowing to connect J-Link to target PCBs via flying wires. Especially useful when hooking up prototype HW where no final connector is decided yet. Or for manually...
€68.00
*
ARM-14 Adapter
Adapter for ARM targets with 14-pin JTAG connector. Incl. 14-pin ribbon cable Additional Product Information on segger.com
€68.00
*
14-Pin TI Adapter
Adapts from .1" 20-pin Standard connector to 14-pin TI connector incl. 14-pin cable Additional Product Information on segger.com
€49.00
*
PPC 14-Pin Adapter
Adapts from 20-pin, 0.1 inch Standard connector to 14-pin, PPC connector incl. 14-pin cable Additional Product Information on segger.com
€49.00
*
Microchip Adapter
Adapts from the standard J-Link 20-pin 0.1" target connector to Microchip RJ11 modular debug connector. Incl. 6-pin RJ11 modular connector cable. Additional Product Information on segger.com
€49.00
*
RX Fine Adapter
Adapts from 20-pin, 0.1‘‘ standard J-Link connector to 14-pin, 0.1" RX FINE connector. Incl. 14-pin cable. Additional Product Information on segger.com
€49.00
*
2mm Adapter
Adapts from 20-pin, 0.1‘‘ standard J-Link connector to 20-pin, 2mm connector. Additional Product Information on segger.com
€49.00
*
Signal Smoothing Adapter
The J-Link Signal Smoothing Adapter can be inserted between the J-Link debug probe and the debug target to overcome signal integrity issues. Additional Product Information on segger.com
€49.00
*
Intel FPGA Adapter
The Intel FPGA Adapter (formerly J-Link Altera Adapter) connects to the 10-pin Intel FPGA JTAG connector providing debug access to FPGA based MCU cores like the dual-core ARM Cortex-A9 in the Cyclone V devices. Incl. 10 pin ribbon cable...
€49.00
*
Xilinx Adapter
Adapts from the standard J-Link 20-pin 0.1" target connector to Xilinx 14 pin 2 mm connector (comp. Platform Cable USB II). Incl. 14 pin 1 mm ribbon cable Additional Product Information on segger.com
€49.00
*
Microchip 2-Wire JTAG TDI Adapter
Adapts from J-Link .1" 20-pin connector to Microchip .1" 6-pin connector. Package includes: 20-pin to 6-pin adapter .1" 6-pin ribbon cable (21 cm) Additional Product Information on segger.com
€49.00
*
Viewed